Non Slip Sock Hot Melt Adhesive

           How to coat the bottom of socks with non-slip Hot Melt Adhesive?

 Preparation

1. A pair of clean gray or black socks
2. A piece of Hot Melt Glue
3. A pair of scissors

Second, production steps
1. Turn the sock around and cut the Hot Melt glue into small pieces with scissors.
2. Evenly apply small pieces of hot melt adhesive to the bottom of the sock, that is, the sole of the foot and the heel of the shoe.
3. Smooth the Binding Agent block by hand to make it closely fit with the sock surface.
4. Let the hot melt glue dry, wait about 5 minutes, until the hot melt glue is completely dry.
5. After the completion of the reverse sock, stretch it, so that the hot melt adhesive non-slip effect is better.

Hot Melt Adhesive For Shoe

Third. use precautions
1. when wearing non-slip socks, do not walk or run quickly on the smooth ground to avoid slipping.
2. every time you wear non-slip socks, you need to clean them, and ensure that the hot melt glue part of the socks is intact.
In short, with a hot glue and a clean pair of socks, you can make your own unique non-slip socks. Not only practical but also can increase the fun of DIY oh!