High Viscosity Hot Melt Glue For EPE Foam

 High Viscosity Adhesive Hot Melt Adhesive For EPE Foam

Operation method

Please pre-heat Eva Resin Binding Agent device before use, preheat time is generally about 2 hours is appropriate.
The amount of glue in the preheated glue pot should be mastered properly, and the colloid will be melted after adding too much, which will make its deterioration and aging, reduce viscosity and affect adhesion.
The bonding and shaping work must be completed within the opening time of the glue, and the clamped adhesive is cooled to room temperature.
Do not touch the glue system with your hands because the temperature is too high. Wear safety protective Equipment to prevent burns.

Matters needing attention

1. the use of places should be well ventilated, away from open flame.

2. Avoid contact with eyes and skin after melting.

3. If the dissolved material comes into contact with the skin, immediately immerse the injured skin in water or rinse with cold water. After cooling, remove the adhesion and then rub the red swelling with silicone oil.